![]() Make sure that you remembered to refill the cartridge with ink. ![]() That’s the signal that the chip has been reset to 100% full. Keep the contact steady until the red light turns green. When the resetter makes contact with the circuit a red light will be lit on top of the resetter. This will collapse the pins and allow them to make contact with the circuit inside the resetter and it will reprogram the chip to read 100% full. You line up the pins on the resetter with the contacts on the chip and press the resetter into the chip. To use our resetter, make certain you only reset a chip after you have refilled the cartridge fully. (That should indicate to you that the chip is not actually associated with the contents of the cartridge. The chips on all of our cartridges read full when you receive them even though they are not yet filled. First of all, you do not need to use a chip resetter when you first install our inks and cartridges.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |